Powermatic 1791284 TS29 Shaper with Sliding Table, 7-1/2HP, 3PH, 230/460V

FEATURES: • Sliding table with 4-foot stroke works with miter head, hold-down and fence to accommodate everything from multiple end cuts to tenons • Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability • Large table with built-in slider with room for stock feeder • 7" vertical spindle travel allows stacked tooling • Spindle tilts negative 5° to positive 45° for increased versatility • Large diameter multiple table inserts accommodate virtually any size cutter • Five spindle speeds in forward and reverse with lighted indicator SPECIFICATIONS: • Electrical Controls: 24 volt • Table Inserts (In.): 2-1/5, 5-1/2, Oval (Tilting) • Reversible: Yes • Spindle Size Under Nut (In.): 3/4 (3-1/2), 1 (6), 1-1/4 (6-1/2) • Recommended Circuit Size (Amps.): 30/15 • Table Travel (In.): 49-1/4 • Maximum Diameter Cutter Above Table (In.): 12 • Maximum Diameter Cutter Below Table (In.): 9 • Motor Phase: 3 • Router Bit Collet Included: 1/4, 1/2 • Dust Collection Minimum CFM Required (CFM): 800 • Fence Travel (Major and Minor) (In.): 5-3/8, 3-5/8 • Spindle Speed (RPM): 3,000, 4,000, 6,000, 8,000, 10,000 • Motor Voltage (V.): 230/460 • Table Size (In.): 51-1/2 x 33-1/2 • Fence Size (L x H) (In.): 46 x 5 • Dust Port Outside Diameter (In.): 5 (x2) • Maximum Spindle Diameter (In.): 1-1/4 • Style (Type): Shaper • Spindle Tilt (Deg.): 45 Forward, 5 Back • Spindle Travel (In.): 7 • Prewired Voltage (V.): 230 • Spindles Included: 3/4, 1, 1-1/4 • Sliding Table Size (In.): 11-1/4 x 51-1/4 • Motor Power (HP): 7-1/2 The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs.